Loosen the bottom half of the adapter first, then fasten the top half to the faucet, and finally tighten the bottom half. Before installation, make sure that the end face of the water outlet of the faucet is flat. If it is not flat, use a file to trim it. Method/step

1. Take out the water inlet pipe fittings of the automatic washing machine, find the end with the water inlet pipe joint, and then press down the slider to separate the water inlet pipe joint from the water inlet pipe.

2. Loosen the four screws on the water inlet pipe joint evenly until the faucet can fit in. If the faucet is too large, you can remove the bushing. Then loosen the plastic interface nut until about 3-4 threads are exposed.

3. Put the water inlet pipe joint on the faucet, close the black washer in the joint to the faucet, and then tighten the screw with a screwdriver.

4. Tighten the plastic interface nut until there is no leakage, and then connect the water inlet pipe and the water inlet pipe joint.

5. Connect the other end of the water inlet pipe to the water inlet of the automatic washing machine, tighten the plastic nut, and the installation is complete.

Choose D&S faucets and we will provide you with the best service.